Ip Address Configuration - Johnson Controls CKM-MR51E Hardware Installation Manual

CKM-MR51E
24-10707-58 Rev. E
Jumper Set at
J1 N/A
J2 N/A
J3 N/A
J4 N/A
J5 PoE
12V
J6 N/A
J7 N/A
4 3 2
OFF OFF OFF
OFF OFF OFF
OFF OFF ON
OFF OFF ON
ON ON ON
1. Public DHCP and Static IP Addressing Modes are available with CKM-MR51E firmware revisions 1.4.2 and
later.
IP A C
DDRESS ONFIGURATION
The CKM-MR51E module uses two addressing modes: static IP addresses or
public DHCP. This section provides information how to set up the static IP
addressing mode. To use public DHCP mode, set up the DIP switches to
"0001" as indicated in
N : If you are using static IP addressing mode, assign a unique IP address
OTE
setting to the CKM-MR51E module before connecting it to the network, to avoid
IP addresses conflict.
Table 2: Jumpers
Description
Factory Use Only
Factory Use Only
Factory Use Only
Factory Use Only
CKM-MR51E powered from the Ethernet connection
CKM-MR51E powered from an external 12 VDC power
source connected to B5-3 (VIN), TB5-4 (GND)
Ethernet Connection with PoE support
Factory Use Only
Table 3: DIP Switches
1 Definitions
OFF MSC-Specific DHCP (original method)
ON Public DHCP
1
OFF Static IP
ON Programming mode for static IP address assignment
ON MSC-Specific DHCP (original method).
Table 3.
9
Hardware Installation Manual
1