Yamaha AN1x Owner's Manual page 79

Dly/ Re v EF
(Dela y/ Reverb Effect)
Delay/ Reverb Effect setting s determine the Delay and
Reverb effect types and data setting s. There are two
parameters available, Param (Parameter) and Data.
The Delay and Reverb effects are located after the EQ output, and can be
connected in series or parallel. For more information, see the separate Data List
book.
Pa r a m
(Pa ra m eter)
The Parameter setting lets yo u select the Co nnect,
Delay effect (and parameters) and Reverb effect (and
parameters).
D a t a
The Data parameter lets yo u select the Co nnect
setting s, Delay type (and chang e data values fo r Delay
parameters) and Reverb type (and chang e data values
fo r Reverb parameters).
Settings:
Fo r info rmatio n abo ut available parameters and value setting s
fo r Delay and Reverb effects, see the separate Data L ist bo o k.
Setting Dela y a nd Reverb
1 . Press the low er a rea of the Pa ra m [UP/ DOW N ]
sw itch to select the Connect pa ra meter.
2 . Press Da ta [UP/ DOW N ] to select seria l (" seri" )
or pa ra llel (" pa ra " ) a nd set the configura tion of
the Dela y a nd Reverb effects.
3 . Press Pa ra m [UP/ DOW N ] a ga in to select either
the Dela y (" DlyEF" ) or Reverb (" RevEF" ) pa ge.
When Delay is
selected, "DlyEF"
appears here
4 . Press Da ta [UP/ DOW N ] a ga in to select the Dela y
type (1 ~ 5 ) or Reverb type (1 ~ 8 ; see the Da ta
List book ).
5 . Press Pa ra m [UP/ DOW N ] a ga in a nd select the
Dela y or Reverb pa ra meter to set (depending on
selected Dela y or Reverb type, a va ila ble
pa ra meters w ill be different).
6 . Press Da ta [UP/ DOW N ] a ga in to set the
pa ra meter va lue a s desired.
7 . Repea t steps 5 a nd 6 , a bove, a s ma ny times a s
necessa ry to set a ll pa ra meter va lues.
79