Yamaha AN1x Owner's Manual page 74

Convenient Pa ra m eter Control
Yo u can use the Co ntro l Matrix sets to assig n a sing le
co ntro ller to co ntro l mo re than o ne parameter, o r multiple
co ntro llers to co ntro l the same parameter.
[Ex . 1 ]
O ne controller to control more tha n one pa ra meter
Set Param Source
1 VCF Cutoff A.MW
2 Resonance A.MW
[Ex . 2 ]
M ultiple controllers to control the sa me pa ra meter
Set Param Source
1 VCF Cutoff A.MW
2 VCF Cutoff A.RbX
Procedure For Using The Control M a trix
1 . Select the Set N o (1 -1 6 ).
2 . Select the Pa ra meter you w a nt to control.
3 . Select the Source (controller) for the pa ra meter
control.
4 . Set the Depth va lue.
5 . Repea t steps 1 -4 to a ssign a dditiona l controller
sets.
For more information about the Control Matrix, the separate Data List book.
Depth
+25
+30
Depth
+20
-10
74
Se t N o
(Set N um ber)
The Set N umber parameter lets yo u select Pitch Bend
Pitch Up and Do wn, the number o f the Set (1 -1 6 ), and
Co mmo n (1 and 2 ) parameter assig nments.
Settings:
PB Pitch ↑:
Selects the Pitch Bend Up parameter fo r setting
the rang e o ver which the pitch bends up (abo ve a value o f
6 4 ) when ro lling the Pitch Bend wheel between center and
maximum fo rward po sitio n (fo r the selected Scene).
PB Pitch ↓:
Selects the Pitch Bend Do wn parameter fo r
setting the rang e o ver which the pitch bends do wn (belo w a
value o f 6 4 ) when ro lling the Pitch Bend wheel between
center and maximum back po sitio n (fo r the selected Scene).
Set 1 ~ 1 6 : Selects the Set N umber to which yo u want to
assig n Parameter, So urce and Depth setting s (fo r the selected
Scene).
Comn 1 ~ 2 (Com m on Set 1 ~ 2 ):
Set number to which yo u want to assig n Parameter (O ff,
Co mmo n Vo lume, Co mmo n Pan, Variatio n Parameter, Delay
Return, Reverb Return), So urce and Depth setting s (applied to
bo th Scenes).
Pa r a m e t e r
The Parameter setting determines which parameter is
assig ned to the Set N umber (1 -1 6 ) o r Co mmo n Set (1 -
2 ). W hen Set N o is set to " PB ↑ " o r " PB ↓ " yo u do n't
need to select the Parameter because these are the
parameters fo r Pitch Bend.
Settings:
Fo r a list o f Co ntro l Matrix parameters, see the separate Data
L ist bo o k.
Selects the Co mmo n