Recoil Starter; Electrical System - Husqvarna 371XP Workshop Manual

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Replacing the generator
1. Before the generator can be replaced, the following
components must be removed:
A. Recoil starter. See page 16.
B. Flywheel. See page 18.
C. Silencer. See page 14.
D. Carburettor. See page 26.
E. Cylinder. See page 37.
2. Detach the carburettor space bottom plate by removing
the four bolts. See fig. 13.
3. Detach the generator by removing the three fixing bolts.
See fig. 14.
4. Disconnect the lead from the on/off switch and lift out the
generator.
5. Locate the new generator as shown in fig. 14 and tighten
the bolts to 4 Nm.
6. Position the lead as shown in fig. 15 and reconnect it to
the on/off switch.
7. Fit the carburettor space bottom plate with the four bolts.
See fig. 13. Ensure that the lead is seated in the recess
in the plate as shown in fig. 15.
Tighten the bolts to 5 Nm.
8. Refit the components from point 1.
Replacing the on/off switch
1. Remove the on/off switch and disconnect the leads. See
fig. 8.
2. Connect the leads to a new switch and press it into place.
Replacing the heating element in the rear hand grip
(tank unit).
1. Before the rear hand grip element can be replaced the
following components must be removed:
A. Tank unit. See page 34.
B. Throttle lock and throttle lever. See page 15.
2. Disconnect the leads, remove the bolts as shown in fig.
16 and remove the heating element.
3. Insert the new heating element, replace the bolts as
shown in fig. 16 and reconnect the cables.
4. Refit the components from point 1.
Replacing the front hand grip
1. Disconnect the two cable clips beside the springs.
2. Remove the five bolts which secure the front hand grip.
3. Fit the new hand grip and replace the five fixing bolts,
tightening them to 4 Nm.
4. Reconnect the two leads.

ELECTRICAL SYSTEM

www.mymowerparts.com
Fig. 13
Fig. 14
Fig. 15
Fig. 16
GB
English – 21