Vitek VT-1331 Manual Instruction page 5

•
•
•
•
•
•
THE UNIT IS INTENDED FOR HOUSEHOLD USE ONLY.
ITS COMMERCIAL USAGE AND USAGE IN PRODUCTION
AREAS AND WORK SPACES IS PROHIBITED.
BEFORE USING THE UNIT FOR THE FIRST TIME
After unit transportation or storage under cold (winter)
conditions, it is necessary to keep it for at least 3 hours
at room temperature before switching on.
•
•
•
USAGE
Wash your hair with shampoo, dry it with a hairdryer and
comb it before styling.
Notes:
•
•
T-1331.indd 5
The power cord should not:
– touch hot objects;
– run over sharp edges;
– be used as a handle for carrying the unit.
Check the integrity of the power cord periodically.
If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or similar
qualified personnel to avoid danger.
Do not attempt to repair the unit. Do not disassemble the
unit by yourself, if any malfunction is detected or after it
was dropped, unplug the unit and apply to any authorized
service center from the contact address list given in the
warranty certificate and on the website www.vitek.ru.
To avoid damages, transport the unit in original pack-
age only.
Keep the unit in a dry cool place out of reach of children
and disabled persons.
Unpack the unit and remove any stickers that can pre-
vent unit operation.
Check the unit for damages; do not use it in case of
damages.
Before switching the unit on, make sure that your home
mains voltage corresponds to the unit operating voltage.
Do not put the operating unit on any surface, but hang
it on the loop (8) instead, making sure that the heating
plates and outer operating surfaces do not come into
contact with fusible and inflammable objects.
During the first operation some foreign smell and a small
amount of smoke from the heating plates is possible,
this is normal.
ENGLISH
5
10/13/20 1:04