Subaru 2000 Legacy Owner's Manual page 355

HBB007BB HBB004FB
4. Slowly pour the coolant and fill to the radiator filler neck and to the
reserve tank's "FULL" level mark. Do not pour the coolant too quickly,
as this may lead to insufficient air bleeding and trapped air in the sys-
tem.
Coolant capacity: MT. 7.2 US qt (6.8 liters, 6.0 Imp qt)
AT. 7.1 US qt (6.7 liters, 5.9 Imp qt)
Rubber gaskets
HG0115
5. Put the radiator cap back on and tighten firmly. At this time, make
sure that the rubber gasket in the radiator cap is correctly in place.
6. Start and run the engine for more than five minutes at 2,000 to
3,000 rpm.
7. Stop the engine and wait until the coolant cools down (122 to
140 F [50 to 60 C]). If there is any loss of coolant, add coolant to the
11-16