Brother HE-800C Instruction Manual page 82

10. TABLE OF ERROR CODES
Code
Machine
E050 immediately before the sewing machine
started operating.
Machine head tilting was detected while
E051
the sewing machine was operating.
Machine head tilting was detected when
E055
the power was turned on.
An operation panel key was still being
E065 pressed when the power was turned on,
or key is faulty.
Upper shaft motor-related errors
Items with a "*" in the "Page" column should only be handled by a qualified technician.
Code
Pulley is not in needle up stop position
E110 during standby when work clamp is
lowered.
The sewing machine could not stop
E111 correctly at the needle up stop position
after sewing.
The needle bar dropped during home
E112 position detection or while the SD card
was being accessed.
Pulley is not in needle up stop position
E113 during standby when work clamp is not
lowered.
Upper shaft motor stopped due to a
E130
problem, or synchronizer is faulty.
E131 Synchronizer is not connected correctly.
73
Cause
head tilting was detected
Cause
Remedy
Turn off the power, and then return the machine head to its
original position.
Check that safety switch connector P14 on the main P.C.
board is properly connected.
Turn off the power, and then return the machine head to its
original position.
Check that safety switch connector P14 on the main P.C.
board is properly connected.
Turn off the power, and then return the machine head to its
original position.
Check that safety switch connector P14 on the main P.C.
board is properly connected.
Turn off the power and check the operation panel.
Remedy
Turn off the power, and then open the slide cover. Align
the mark (A) on the pulley within the edges of the mark (B)
on the motor cover.
Turn off the power, and then check that there are no
problems with the cutter mechanism, the thread trimming
mechanism and the upper shaft motor mechanism.
Turn off the power, and then turn it back on again.
* If this error occurs when the work clamp is not lowered,
the work clamp will drop automatically in order to
prevent interference between the needle and the lower
thread retainer.
Turn off the power, and then open the slide cover. Align the
mark (A) on the pulley within the edges of the mark (B) on
the motor cover. (Refer to the diagram for "E110" above.)
* If this error occurs, the work clamp will drop
automatically in order to prevent interference between
the needle and the lower thread retainer.
Turn off the power, and then open the slide cover. Turn
the pulley to check if the machine has locked up.
Check that the upper shaft motor 4-pin (UVW) connector
and synchronizer connector P11 on the motor P.C. board
are properly connected.
Turn off the power, and then check that synchronizer
connector P11 on the motor P.C. board is properly
connected.
HE-800C
Page
10*
10*
10*
*
Page
*
4886M
*
–
*
*
11*
11*