Brother HE-800C Instruction Manual page 59

3
Depress the treadle to the 2nd step (C).
4822M
4
Test feeding in progress
・ When the treadle is returned to the neutral position, test feeding will be
interrupted.
・ If the treadle is depressed to the 2nd step (C), test feeding operation will
move forward.
・ Test feeding operation moves forward by one stitch each time the
is pressed.
(The key changes operation to the opposite direction.)
・ When the cutter operating position is reached, the buzzer will sound and
the cutter icon will be displayed for one second.
* If you press the AUTO key, test feeding mode will be exited and the
sewing machine will switch to the automatic sewing standby condition.
<Manual sewing method>
Turn the pulley (4) by hand in the direction of the arrow
during test feeding.
・ Feeding will move forward by one stitch for each
rotation of the pulley (4).
・ Test feeding operation by turning the pulley (4) by
hand also moves the needle up and down, so if
material has been set and the sewing machine is
threaded with thread, manual sewing can be carried
out.
5
Test feeding complete
When the number of stitches remaining reaches "0", depress the treadle to the 2nd step (C).
4822M
NOTE:
If you press the RESET key during test feeding or after test feeding is complete, the needle bar and the work clamp will
carry out home position detection, and then they will return to the sewing start position.
6. USING THE SEWING MACHINE (SEWING OPERATION)
The work clamp will drop, and test feeding will start.
* However, if the sewing data is protruding outside the sewing area,
"OVER SEW AREA" will be displayed for 1.5 seconds, and test
feeding will not be carried out.
・ The above message will be displayed for 1.5 seconds.
・ The work clamp will rise, and test feeding mode will be exited.
HE-800C
key
Number of stitches
remaining
4823M
4824M
4825M
4921M
50