Table of Contents
Advertisement
■
[Multi control auto setting(DIGITAL LINK)]
When connected with the DIGITAL LINK daisy chain,
display IDs are automatically assigned to all the
displays, and the serial IN/OUT terminals, remote control
IN/OUT terminals and the network are automatically set.
Select [Multi control auto setting(DIGITAL LINK)]
with
and press <ENTER>.
Multi control auto setting(DIGITAL LINK)
Status
DIGITAL LINK daisy chain
020/025
Display ID
Network control / IP address
Off
Serial ID / Terminal
On
Serial out terminal
Controller ID / Terminal
On
Controller out terminal
Start
Display ID
Changing network control
Changing Serial/IR terminal
The following screen is displayed on the subsequent-
stage displays.
Multi control auto setting(DIGITAL LINK)
Status
DIGITAL LINK daisy chain
021/025
Display ID
Network control / IP address
Off
[Status]
Displays the execution state of the display ID auto
setting.
[Wait]:
ID auto setting has not been executed yet.
[Finished]:
ID auto setting is completed.
[DIGITAL LINK daisy chain]
Displays the connection number counted from the
first unit to this unit out of total displays connected via
DIGITAL LINK.
[Display ID]
Displays the current display ID.
[Network control / IP address]
Displays [On] / [Off] of [Network control] function and
IP address.
[Serial ID / Terminal]
Displays ON/OFF of the function to control with
ID, and displays the terminal to use when serial-
controlling.
[Serial out terminal]
Displays the terminal used for the serial
communication output.
Wait
0
192.168.0.8
SERIAL IN
SERIAL OUT
Built-in
IR OUT
1
Yes
Yes
Wait
0
192.168.0.8
[Controller ID / Terminal]
Displays ON/OFF of the function to control with ID,
and displays the terminal to use when controlling with
the remote control.
[Controller out terminal]
Displays the terminal used for the remote control
communication output.
Set each item.
Multi control auto setting(DIGITAL LINK)
Status
DIGITAL LINK daisy chain
020/025
Display ID
Network control / IP address
Off
Serial ID / Terminal
On
Serial out terminal
Controller ID / Terminal
On
Controller out terminal
Start
Display ID
Changing network control
Changing Serial/IR terminal
[Display ID]
Sets the ID you want to assign to the display you are
operating.
[Auto], 1 to 100
When setting to [Auto], the ID is set using the
number counted from the first unit connected with
the DIGITAL LINK daisy chain.
Example: 15th unit counted from the beginning
ID: 15
Note
●
When connected with the DIGITAL LINK daisy chain,
the ID number and control terminal are automatically
set for the preceding-stage display before the display
on which the operation is performed.
[Changing network control]
Sets whether to change settings in [Network control]
or maintain the current settings.
[No]:
Maintains the settings.
[Yes]:
Switches [Network control] to [On] when it is set to
[Off], and switches [DHCP] to [On].
Wait
0
192.168.0.8
SERIAL IN
SERIAL OUT
Built-in
IR OUT
1
Yes
Yes
English
55
Advertisement
Table of Contents
