Table of Contents
Advertisement
The LAN is uncontrollable.
There is no picture displayed or sound output from
the [DIGITAL LINK] terminal.
LCD Display panel
The screen darkens slightly when bright pictures
with minimal movements are shown.
It takes a while for the picture to appear.
The edges of the images flicker.
There may be red spots, blue spots, green spots
and black spots on the screen.
Image retention appears
This LCD Display uses special image processing. Hence a slight time lag may occur between image and audio,
depending on the type of input signal. However, this is not a malfunction.
118
English
Symptoms
Symptoms
Check that the connection has been made properly.
(see page 81)
To control with WEB browser control or command control,
check that [Network settings] - [Network control] is set to
[On].
(see page 68)
Check that [LAN setup] is set properly.
(see page 68)
When connecting to a device of AMX, Extron or Crestron
Electronics, Inc., set [AMX D. D.], [Extron XTP] or [Crestron
Connected™] according to the device to use.
(see page 70)
See the [DIGITAL LINK status] - [Signal quality] information
to check the LAN cable status such as whether the LAN
cable is disconnected or the cable is not shielded.
(see page 70)
Check whether the connection has been made properly
between the video (output) equipment and twisted pair cable
transmitter and between the twisted pair cable transmitter
and this product.
(see page 82)
Check that [Network settings] - [DIGITAL LINK mode] is not
set to [Ethernet].
(see page 69)
The screen will darken slightly when photos, still images of
a computer or other pictures with minimal movements are
shown for an extended period. This is done to reduce image
retention on the screen and the shortening of the screen's
service life: It is normal and not indicative of malfunctioning.
The unit digitally processes the various signals in order
to reproduce esthetically pleasing images. As such, it
sometimes takes a few moments for the picture to appear
when the power has been turned on, when the input has
been switched.
Due to the characteristics of the system used to drive the
panel, the edges may appear to flicker in the fast-moving
parts of the images: This is normal and not indicative of
malfunctioning.
This is a characteristic of liquid crystal panels and is
not a problem. The liquid crystal panel is built with very
high precision technology giving you fine picture details.
Occasionally, a few non-active pixels may appear on the
screen as fixed points of red, blue, green, or black. Please
note this does not affect the performance of your LCD.
Image retention may occur. If you display a still picture for
an extended period, the image might remain on the screen.
However, it will disappear when a general moving picture is
displayed for a while. This is not considered as malfunction.
Check
Check
Advertisement
Table of Contents
