Table of Contents
Advertisement
■
[IR out]
Sets the terminal used for the IR signal output.
[IR OUT]: IR output terminal
[DIGITAL LINK]: DIGITAL LINK OUT terminal
■
[Serial control]
Sets the terminal used for the serial communication
input.
[SERIAL IN]: Serial terminal
[DIGITAL LINK]: DIGITAL LINK IN terminal
■
[Serial out]
Sets the terminal used for the serial communication
output.
[SERIAL OUT]: Serial output terminal
[DIGITAL LINK]: DIGITAL LINK OUT terminal
■
[Display ID]
Set ID number when controlling the Display with
[Controller ID function] and [Serial ID function].
0 to 100 (Standard value: 0)
■
[Controller ID function]
Enables/disables the [Controller ID function].
[Off]:
Disables the [Controller ID function]. (Can be
operated as normal remote control.)
[On]:
Enables the [Controller ID function]. Effective on
switching to [On].
Note
●
To use the [Controller ID function], setting ID numbers
both for the remote control and for the display unit is
required.
For ID number setting for the remote control, see
page 111.
●
About how to reset the settings to defaults:
"Initialization" (see page 80)
■
[Serial ID function]
Set to control external control with the PC connected to
SERIAL terminal according to the Display's ID number.
[Off]:
Disables external control by the ID.
[On]:
Enables the external control by the ID.
54
English
■
[Serial response (Normal)]
Sets whether to send the response command to normal
commands without ID.
[Off]:
Does not respond. (Including the inquiry command)
[On]:
Responds.
■
[Serial response(ID all)]
Set whether to respond to the command or not, when
serial command of ID number "0" is received.
[Off]:
Does not respond.
[On]:
Responds.
■
[Serial ID group]
When controlling multiple displays simultaneously via
serial communication, those displays are grouped as
one.
A to G (7 groups)
■
[Serial response(ID group)]
Sets whether to respond to the command or not,
when serial command, which the group is specified, is
received.
[Off]:
Does not respond.
[On]:
Responds.
■
[Serial daisy chain position]
Sets the first and the last terminals of the daisy chain
connection when serial-controlling this unit by the
daisy chain connection (including connection via the
SERIAL IN/OUT terminal or via DIGITAL LINK, or mixed
connection).
[---]:
When controlling this unit alone with serial control, or
connecting at a position other than the first and last
terminals in a daisy chain
[Top]:
When connecting at the first terminal in a daisy chain
[End]:
When connecting at the last terminal in a daisy chain
Advertisement
Table of Contents
