Toshiba MMC-AP0157HP1-E Service Manual page 97

No. Part name
PMV motor
10
1. Detachment
(Pulse
1) Recover the refrigerant gas.
Motor Valve)
2) Perform work of 1 of 1, 1 of 2, 1 of 7,
1 of 8 and 1 of 9.
3) Remove the PMV connector (CN82,
Blue, 6P) from the control P.C. board
and remove the PMV lead from lead
clamp (5 positions)
4) The screw of the partition plate is
removed while holding the heat
exchanger and the partition plate is
detached.
(Ø4 × 10, 4 pcs.)
5) Cut off binding band that binds the PMV
lead wires.
6) The main body of PMV is exposed
cutting the butyl rubber with the cutter
etc.
7) Loosen the nuts fixing PMV with double
spanner to remove PMV.
NOTE
use a 19 mm spanner wrench.
8) The screw of the fixing plate is removed
and the fixing plate is removed.
(Ø4 × 10, 2 pcs.)
9) The PMV lead is detached from the
partition plate.
2. Attachment
1) Mount PMV motor with a spanner wrench.
2) Covers with the butyl rubber of the main
body of PMV as before.
3) Fasten the parts as before in order,
Procedure
– 97 –
FILE NO. SVM-16042
Remarks
PMV connector
Lead clamp
Lead clamp
Partition plate
Screws
PMV lead
PMV
Binding band
Partition plate
Fixing plate
Screws