Toshiba MMC-AP0157HP1-E Service Manual page 95

No. Part name
Under panel
8
1. Detachment
1) Perform works of 1 of
2) Remove the support plate.
The screw on a front side is removed,
and it detaches it from the square
hole on the back side.
3) The screw on both sides is removed.
4) The screw on fan side is removed.
5) Slide to the air discharge side and
NOTE
When you remove forcibly which
may result in the product breaks.
6) When you remove the signal receiving
2. Attachment
1) Attach the under panel from air
2) Attach the screws as original position.
Procedure
7
(AP024 to AP056 type only) (Ø4 x 10, 1 pc.)
(Ø4 x 10, 2 pcs.)
AP015 to AP027 type : (Ø4 x 10, 3 pcs.)
AP036 to AP056 type : (Ø4 x 10, 4 pcs.)
remove the under panel.
unit, lap the end of flat head screw
driver with vinyl tape, and forcedly
insert it into the groove at the side
under circle mark on the cover.
Flat blade screwdriver
(Lap it with vinyl tape.)
Vinyl tape
Insert it into groove at
the side under circle
mark on the cover.
discharge side according to drain pan.
80-160 type attach the support plate as
original position.
.
Cover
– 95 –
FILE NO. SVM-16042
Remarks
Square hole
Front side screw
Support plate
Screws
Screws
Screws