Table of Contents
Advertisement
How to change all indoor addresses from an arbitrary wired remote controller
(It is possible when setting has finished by automatic addresses.)
Contents: The indoor unit addresses in each identical refrigerant piping line can be changed from an
arbitrary wired remote controller.
Enter in address check/change mode and then change the address.
<Procedure> Carry out this procedure during stop of system.
1
Push the timer time button
First line 1 and CODE NO.
2
Select line address using
3
SET
Push the
button.
The address of the indoor unit connected to the
refrigerant piping of the selected outdoor unit is
displayed and the fan and the louver are on.
First the current indoor address is displayed.
(Line address is not displayed.)
4
TIME
button push up/down the indoor
address of the SET DATA.
The set data is changed to a new address.
5
SET
Push
button to determine the set data.
6
UNIT LOUVER
Every pushing
the indoor unit No. in the identical piping is
displayed one after the other.
Only fan and louver of the selected indoor unit
start operation.
Repeat the Procedures
indoor addresses so that they are not duplicated.
7
SET
Push
button.
(All the indications of LCD go on.)
8
TEST
Push
button and then the procedure
finishes.
TEST
+
simultaneously for 4 seconds or more.
(Address Change) are displayed.
UNIT LOUVER
SWING/FIX
/
button.
(left side button) button,
4
6
to
to change all the
– 48 –
TEMP.
TIMER SET
1
TIME
FILTER
RESET
TEST
SET
CL
3
Cancel of line selection
If the UNIT No. is not call up here, the outdoor unit
in that line does not exist.
CL
Push
button to select a line again in the
2
Procedure
.
TEMP.
TIMER SET
8
TIME
FILTER
Finish
RESET
TEST
SET
CL
5
<Operation procedure>
1
2
3
6
7
8
END
FILE NO. SVM-16042
ON / OFF
FAN
MODE
SAVE
VENT
SWING/FIX
UNIT LOUVER
ON / OFF
FAN
MODE
SAVE
VENT
SWING/FIX
UNIT LOUVER
When you want to
complete the setting
4
5
2
4
6
7
Advertisement
Table of Contents
