Care & Maintenance; Error Codes - Rinnai 650 Operation Manual

CARE & MAINTENANCE

ERROR CODES

In all cases, you should be able to clear the Error Code on display simply by turning the heater
'OFF', then 'ON' again. If the Error Message still remains or returns on the next operation, contact
Rinnai or your nearest service agent and arrange for a service call.
WARNING
Your Rinnai Gas Fire is also
fitted with self diagnostic
electronics that monitor the
appliance during start-up and
operation.
Should a fault occur
appliance will then shut down,
the fault that has caused the
shut down will be indicated by
a pair of flashing digits in the
Error Display window
7
is located behind the fascia and
can be viewed by looking down
between the glass of the dress
guard and the burner box.
Refer to the table
for probable cause and the
suggested remedy.
Code Possible Cause
Mains power failure
00
Ignition failure
11
Incomplete combustion
12
Inlet Blockage /Overheat
14
Room overheat
16
Room temperature sensor faulty
31
Overheat temp. 1 sensor faulty
32
Overheat temp. 2 sensor faulty
33
Spark sensor faulty
53
Combustion fan motor faulty
61
Solenoids faulty
71
Flame detection circuit fault
72
Communication error
73
The appliance is fitted with an overheat safety switch which will shut off the appliance. If the appliance shuts off
repeatedly servicing or inspection of the flue for may be required, contact Rinnai for advice.
Rinnai
7
Error Code Viewing Window
the
, which
7
below
Reset the heater, press the Standby / ON button on the control
panel, remote control, or app twice, to turn the fire back on.
Check that the gas supply is turned on. Switch the heater to
STANDBY and then ON again If the error persists, a service call
will be required.
As above.
Clean inlet, if the error persists, a service call will be required
Lower room temperature to below 40 °C.
Service call.
Service call.
Service call.
Service call.
Service call.
Service call.
Service call.
Service call.
Suggested Solution
12
c
8
1 a
RDV 600_700ER OM