Calibration Adjustment - Ford 1996 Explorer Manual

Calibration adjustment:

Find an open area that is free from steel structures and high
1.
voltage lines. An open parking lot is a good example.
Press and hold the "MODE" button until the "CAL"
2.
indicator appears in the display (approximately 8 seconds).
NOTE: You cannot perform calibration unless the display
reads "CAL."
Release the "MODE" button.
3.
Once the "CAL" indicator has appeared, drive the vehicle
4.
slowly (less than 3 mph / 5 km/h) in 360˚ circles until the
"CAL" indicator turns off. This will happen within 2 to 3
complete circles.
Map lamps
The map lamps are located in the overhead console. The driver
and passenger side each has its own switch.
Map lamps (If equipped)
200