Filling The Fuel Tank - Ford 1996 Crown Victoria Manual

Cleaning the Engine
A clean engine is more efficient because a
buildup of grease and dirt acts as an insulator,
keeping the engine warmer than usual.
Extreme care must be used if a power washer
is used to clean the engine. The high pressure
fluid could penetrate sealed parts and
assemblies causing damage or malfunctions.
In order to avoid possible cracking of the
engine block or fuel injection pump, do not
spray a hot engine or injection pump with
cold water.
The alternator, distributor and air intake must
be covered. Covering these components will
help prevent water damage.
Never wash or rinse the engine while it is
running. Water getting into the engine may
cause internal damage.

Filling the Fuel Tank

The fuel filler door is outside the vehicle on the
driver's side near the back. To fill the fuel tank:
1. After opening the fuel filler door, remove
the cap carefully and slowly by turning it
counterclockwise 1/2 to 3/4 turn.
The fuel system may be under pressure. If
the fuel cap is venting vapor or if you
hear a hissing sound while disengaging
the fuel cap, wait until it stops before
completely removing the cap. Otherwise,
fuel may spray out and injure you or
others.
RWARNING
239