Ford 1996 Crown Victoria Manual page 168

Using the "TUNE" function
You can change the frequency up or down
one increment at a time by pressing and
releasing either the left b or right a side of
the "TUNE" button. To change frequencies
quickly, press and hold down either the right
or left side of the "TUNE" button.
Manual tuning adjusts your radio to any
allowable broadcast frequency, whether or
not a station is present on that frequency.
(See All About Radio Frequencies in this
section.)
Using the "SEEK" function
Press the right a side of the "SEEK" button
to select the next listenable station up the
frequency band. Press the left b side of the
button to select the next listenable station
down the frequency band. By holding the
button down, listenable stations can be
passed over to reach the desired station.
Using the "SCAN" function
Pressing the "SCAN" button will begin the
scan mode up the frequency band, stopping
on each listenable station for approximately
five seconds.
To stop the scan mode on the presently
sampled station, press the "SCAN" button
again.
Setting the station MEMORY PRESET buttons
Your radio is equipped with 6 station
memory buttons. These buttons can be used
to select up to 6 preset AM stations and 12
FM stations (6 in FM1 and 6 in FM2)
Follow the easy steps below to set these buttons
to the desired frequencies:
1. Select a band, then select a frequency.
152