Ford 1996 Aspire Manual page 194

Engine coolant refill procedure
When the entire engine cooling system is to be
drained and refilled, use the following
procedure:
1. Remove the radiator cap.
2. With the engine off and cool, add a 50/50
mixture of recommended engine cooling
system fluid and water until the radiator is
full.
3. Replace and fully tighten the radiator cap,
then unscrew the cap to the first stop.
4. Start and idle the engine until the radiator
upper hose is warm (this indicates the
thermostat is open and engine coolant is
flowing through the entire system).
5. When you are done, stop the engine and
tighten the cap completely.
Checking hoses
Check all engine and heater system hoses and
hose connections for deterioration, leaks, and
loose hose clamps as specified in the
maintenance schedule. Repair or replace with
Motorcraft hoses or equivalent as necessary.
Windshield Washer Fluid and
Wipers
Washer Fluid
Check the level of the windshield washer fluid
every time you stop for fuel. The reservoir for
the windshield washer fluid is located in the
engine compartment.
To check the washer fluid level, place your
finger over the hole in the reservoir cap and pull
out the dipstick.
195