Turn And Lane-Change Signals (Auto Signal); Headlamp High/Low-Beam Changer; Flash-To-Pass - Chevrolet 2010 Corvette Owner's Manual

Turn and Lane-Change Signals
(Auto Signal)
Move the lever all the way up or down to signal
a turn.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Release the lever and the turn
signal automatically flashes three times. If more flashes
are desired, continue to hold the lever.
The lever returns to its starting position when it is
released.
If after signaling a turn or lane change the arrows flash
rapidly or do not come on, a signal bulb may be
burned out.
Have the bulbs replaced. If the bulb is not burned out,
check the fuse. See Fuses and Circuit Breakers on
page 6-103.
An arrow on the instrument
panel cluster flashes in the
direction of the turn or lane
change.
Turn Signal on Chime
A chime sounds if the turn signal has been on for more
than three-quarters of a mile (1.2 km) of driving.
If you need to leave the turn signal on for more than
three-quarters of a mile (1.2 km), turn off the signal and
then turn it back on.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high, push
the turn signal lever all the way forward. To change from
high to low beam, pull the lever rearward.

Flash-to-Pass

To use the flash-to-pass feature, briefly pull the turn
signal lever toward you. The high-beam indicator flashes
to indicate to the other driver that you intend to pass.
If the low-beam headlamps are off and the fog lamps are
on, the fog lamps flash.
While the high beams
are on, this light on the
instrument panel cluster
will also be lit.
4-5