Headlamp Aiming - Chevrolet 2010 Camaro Owner's Manual

9-34 Vehicle Care
3. With the latch open, pull the
wiper blade down towards
the windshield far enough to
release it from the J-hooked
end of the wiper arm.
4. Remove the wiper blade.
Allowing the wiper blade arm to
touch the windshield when no
wiper blade is installed could
damage the windshield. Any
damage that occurs would not be
covered by the vehicle warranty.
Do not allow the wiper blade arm
to touch the windshield.
5. Reverse steps 1 through 3 for
wiper blade replacement.

Headlamp Aiming

The headlamp aiming system has
been preset at the factory.
If the vehicle is damaged in an
accident, the aim of the headlamps
may be affected and adjustment
may be necessary.
It is recommended that a
dealer/retailer adjust the headlamps.
To re-aim the headlamps yourself,
use the following procedure.
The vehicle should be properly
prepared as follows:
•
The vehicle should be placed so
the headlamps are 7.6 m (25 ft)
from a light colored wall.
•
The vehicle must have all four
tires on a level surface which
is level all the way to the wall.
•
The vehicle should be placed so
it is perpendicular to the wall or
other flat surface.
•
The vehicle should not have any
snow, ice, or mud on it.
•
The vehicle should be fully
assembled and all other
work stopped while headlamp
aiming is being performed.
•
The vehicle should be normally
loaded with a full tank of fuel and
one person or 75 kg (160 lbs)
sitting on the driver's seat.
•
Tires should be properly inflated.
Headlamp aiming is done with the
vehicle's low-beam headlamps.
The high-beam headlamps will be
correctly aimed if the low-beam
headlamps are aimed properly.