Advertisement
SECTION 6 – NEEDLE INSTALLATION
Needle Installation:
To install the needle:
Place the desired Needle Retention Nut on to the Needle Retention
Nut Base by two threads counter clockwise as shown below. This
keeps the Needle covered during the installation. Place the O-Ring
for the Conical Needle on the front portion of the injection device as
shown.
Apply one drop of lubricant to the O-Ring.
Place the Conical Needle over the O-Ring, as shown below.
Then while holding on to the Inlet Valve Nut so that it does not turn, secure the Conical Needle to the device by
rotating the Needle Retention Nut Base clockwise.
When you are ready to administer injections, turn the Needle Retention Nut counterclockwise to expose the
Needle. Turn the Needle Retention Nut until it is snug - finger tighten only.
O-Ring
Inlet Valve Nut
Needle Retention
Nut
Needle Retention
Nut Base
10
Advertisement
