Advertisement
SEEK:
Press this button to go
to
the next higher station
and stop.
SCAN: Press this button to listen to each station for
a few seconds. The radio will go to the next station,
stop for a few seconds, then go to the next station.
SCAN will appear on the display. Press SCAN again
to stop scanning.
PUSHBUTTONS: The four numbered pushbuttons let
you return to your favorite stations. You can set up to
14 stations (seven AM and seven FM).
I . Tune in the desired station.
2. Press SET.
3. Press one of the four pushbuttons, within five
seconds,
to
store the station. Whenever you press
that numbered button, the station you set will return.
4. Repeat the steps for each pushbutton.
In addition to the four stations set as above, up to
three additional stations may be preset on each band by
pressing two adjoining buttons at the same time. Just:
I . Tune in the desired station.
2. Press SET. (SET will appear on the display.)
3. Press two adjoining pushbuttons at the same time,
within five seconds. Whenever you press the same
two buttons, the station you set will return.
4. Repeat these steps for each pair of buttons.
AM-ST Press this button
to
tune- an AM station that
broadcasts in stereo. Your STEREO light will come on
when you're receiving AM stereo. If you press AM-ST
and there is no more noise, it means the station is weak.
You'll hear the station better if you do not use AM-ST.
Press the button again to delete stereo.
Advertisement
