Table of Contents
Advertisement
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns when it is released.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned
bulb. (This does not occur with a burned
Other drivers won't see the turn signal. Replace
-
burned
out bulbs to help avoid possible accidents.
Check the fuse (see "Fuses and Circuit Breakers" in the
-
Index) and for burned
out bulbs if the arrow fails to
work when signaling a turn.
Headlamp High/Low Beam
With the Twilight Sentinel
dial turned to the headlamp position, push the turn
signal lever on the driver's side of the steering wheel
away from you to turn on the high
-
out front signal
-
out rear bulb.)
R
on or with the lamp control
-
beam headlamps.
This light on the instrument
panel will be on, indicating
-
high
beam usage.
Pull the lever back to the original position to return to
-
low
beam headlamps. For more information, see
"Headlamps" in the Index.
Flash-To-Pass
This feature uses the high
driver in front of you that you want to pass. This feature
will work with either the headlamps on or off.
To use, pull the turn signal lever toward you and release.
Windshield Wipers
WIPER: Move the lever on the passenger's side of the
steering wheel up and down to control the wipers.
yellowblue
-
beam headlamps to signal the
2-35
Advertisement
Table of Contents
