Cub Cadet 900 Series Professional Shop Manual page 45

8. Loosen the bolt that holds the left pedal shaft
support strap using a 1/2" wrench.
See Figure 5.26.
Left pedal shaft support strap
Figure 5.26
9. Remove the bolt that holds the right pedal shaft
support strap using a 1/2" wrench.
NOTE: This will allow the pedal shaft assembly
to hang-down slightly on the right side of the
tractor.
10. Disconnect the drive control rod from the drive
pedal latch plate. See Figure 5.27.
• Remove and discard the cotter pin.
• Unhook the drive control rod.
Figure 5.27
11.
12.
•
•
Drive control
rod
Drive pedal
latch plate
HYDRO. DRIVE AND BRAKE SYSTEM
Allow the drive pedal shaft to rotate down, then
pull it off of the pedal shaft assembly.
See Figure 5.28.
Figure 5.28
Disconnect the brake rod from the clutch/brake
latch plate. See Figure 5.29.
Remove the cotter pin and flat washer to discon-
nect the brake rod. Discard the cotter pin.
Unhook the brake rod from the clutch/brake latch
plate.
Clutch/brake
latch plate
Figure 5.29
Drive control
pedal shaft
Brake rod
Flat washer
39