Transaxle Installation; Assembly After A Complete Teardown - Cub Cadet 900 Series Professional Shop Manual

TRANSAXLE INSTALLATION

Use the following procedure to complete the
installation of the transaxle on the vehicle.
1. Install and secure the transaxle on the
vehicle according to the instructions in the
vehicle owner's manual.
2. With the vehicle raised, install the wheels
on the axles, and snug the wheel hardware.
3. Lower the vehicle wheels to the ground and
torque the wheel hardware per the vehicle
owner's manual.
310-0510 IHT
ASSEMBLY AFTER A COMPLETE
TEARDOWN
If the unit has been torn down completely, the
following summary identifies the assembly pro-
cedures necessary to completely assemble the
unit. Each assembly procedure is located by a
page reference.
The part reference numbers provided in each
assembly procedure are keyed to the individual
exploded views, and are also keyed to the
complete unit exploded view on page 32.
1. Install the hydraulic components. See
pages 23-26.
2. Install the input shaft. See page 22.
3. Install the bypass rod. See page 21.
4. Install the axle shaft, differential and reduc-
tion gears. See page 20.
5. Install the side housing. See page 19.
6. Install new seals in the side housing. Refer
to page 18.
7. Fill the transaxle with new oil. See page 10.
8. Install the control arm and friction pack.
See page 17.
9. Install the brake assembly and bypass arm.
See page 16.
10. Install the transaxle onto the vehicle.
11. Perform the purge procedures listed on
page 11.
12. Perform the return to neutral procedure on
page 12.
27