Cub Cadet 900 Series Professional Shop Manual page 138

Cutting Decks And Lift Shaft
B. Remove the nut that secure the belt guard
to the right side of the frame using a 1/2"
wrench. See Figure 8.2.
Figure 8.2
C. Pull in on the belt guard and slide it towards
the rear of the tractor.
D. Slide the PTO belt off of the engine pulley.
E. Remove the hair pin clip that secures the
PTO cable to the deck. See Figure 8.3.
Remove this clip
Figure 8.3
132
Remove this
nut
F. Unhook the spring end of the PTO cable
from the idler pulley bracket.
See Figure 8.4.
Unhook this spring
Figure 8.4
4. Pull the deck pins on both sides and rotate them
to keep them out. See Figure 8.5.
Figure 8.5
Pull and rotate the deck pin