Pedal Shaft Assembly Removal - Cub Cadet 900 Series Professional Shop Manual

HYDRO. DRIVE AND BRAKE SYSTEM

Pedal shaft assembly removal

NOTE: Confirm that the parking brake is
released before starting work.
1. Remove the mowing deck.
2. Remove the fenders, as described in the body
panels chapter of this manual.
3. Disconnect the rod that joins the arm at the left
side of the brake/clutch shaft to the drive belt
tensioner pulley bracket. See Figure 5.22.
• Remove and discard the cotter pin to disconnect
the rod.
Clutch/brake shaft
Figure 5.22
4. Remove the locking clip that holds the travel limit
pin in place.
5. Withdraw the travel limit pin. See Figure 5.23.
Travel limit pin
Figure 5.23
38
6.
Clutch/brake pedal
return spring
Rod
7.
Tie-rod
separator
Latch plates
Unhook the clutch/brake pedal return spring.
See Figure 5.24.
Hooks to clutch/brake
latch plate
Figure 5.24
Remove and discard the push cap that holds the
drive control pedal shaft onto the clutch/brake
shaft. See Figure 5.25.
Figure 5.25
Hooks to frame
Push cap