Table of Contents
Advertisement
10. ADJUSTMENTS
CARRIAGE POSITION LEFT AND RIGHT
1
.
Override the SBS-INTERLOCK with 2 PERMANENT MAGNETS (PN 544240). Place
them above the REED CONTACTS on either side of the SBS
2
.
Load TEST FILMS into to ML700 to avoid fogging of CUSTOMER FILMS.
3
.
Run a few cycles with different CASSETTE SIZES and observe the film transport
through the SBS.
4
.
Check that large films are transported centred into the SBS-CARRIAGE from the
ML700. If the FILM is not centred, continue with step 5, else continue with step 6.
5
.
Turn the SENSOR POSITION SCREW of SENSOR B3/4 (adjust the SENSOR on the
ML700 side of the SBS) in or out as required and go back to step 3.
SENSOR B3 detects the left-hand position of the CARRIAGE
SENSOR B4 detects the right-hand position of the CARRIAGE.
If necessary move the SENSOR MOUNT up or down, so that the CARRIAGE FLAG is
midway in between. This midway position is not critical.
SENSOR MOUNT
KODAK AG, Stuttgart
SENSOR POSITION SCREW
figure 10-1
10-1
II 3066-2
10/98
Advertisement
Table of Contents
