Table of Contents
Advertisement
Chapter 3
Set Supervisor/User Password
When you select this function, a message as below will appear on the
screen:
CMOS Setup Utility - Copyright(C) 1984-2001 Award Software
?
Standard CMOS Features
?
Advanced BIOS Features
?
Advanced Chipset Features
?
Integrated Peripherals
?
Power Management Setup
?
PnP/PCI Configurations
?
PC Health Status
ESC : Quit
F10 : Save & Exit Setup
Type the password (up to eight characters in length) and press <Enter>.
The password typed now will clear any previously entered password from
CMOS memory. You will be asked to confirm the password. Type the pass-
word again and press <Enter>. You may also press <Esc> to abort the selec-
tion and not enter a password.
To disable a password, just press <Enter> when you are prompted to enter
the password. A message will confirm the password will be disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
When a password has been enabled, you will be prompted to enter it
every time you try to enter Setup. This prevents an unauthorized person from
changing any part of your system configuration.
Enter Password:
F9 : Menu in BIOS
Time, Date, Hard Disk Type...
?
Frequency/Voltage Control
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
? ? ? ? ? ? ? ? ? ? : Select Item
3-36
Advertisement
Table of Contents
