1. Prepare the Ethernet cable:
①
②④
③
⑤
Figure 5-12
– Strip the Ethernet cable
– Insert the Ethernet cable through the cable gland. Make sure that the exposed
– Screw down the cable gland
2. Fasten the prepared gland at the position
⑥
⑦
Figure 5-13
Connecting the Ethernet cable
1. Strip the end of the cable.
2. Assemble stripped cores in a FastConnect plug.
3. Insert the Ethernet plug in the service interface of the processing module. You must feel
for the position of the interface.
Quick Start
Compact Operating Instructions, 06/2017, A5E31805656-05
Cable gland
Contact shielding
Ethernet cable
Shielding braid
Ethernet cable shielding
a length of approx. 1 cm.
shielding braid rests on the shield contact
Cable gland plate
Position of cable gland of Ethernet cable (device bottom)
Ethernet cable: Position of the cable gland
③
at the desired location so that the braid
②
or
⑦
on cable gland plate (device bottom).
5.1 Electrical connections
⑤
is exposed over
④
.
Connecting
53