Simple Setup For Wireless Lan - Epson TM-T88VII Technical Reference Manual

Simple Setup for Wireless LAN

The printer has "SimpleAP" mode that allows a device to directly connect to the printer without using an access
point. You can configure wireless LAN settings using the printer setting tool and print on the printer using the
direct connection.
• The printer acts as an access point in the SimpleAP mode and allows up to eight devices to connect
• Connection to a wireless LAN or wired LAN and connection using the SimpleAP mode can be made
• Communication between devices connected to the printer in the SimpleAP mode is impossible.
• If the printer is already connected to a wireless LAN and setting using the SimpleAP mode is
• If you change the passphrase, connection using SimpleAP from an Android 10 device is disabled. It
SimpleAP is enabled by default. The printer automatically prints the information shown below when it is turned
on with the following conditions; SimpleAP enabled, not connected to a wireless LAN/wired LAN/USB device,
and wireless LAN settings have not been configured.
The printer activates SimpleAP when it is turned on for the first time, however, if you change the printer
settings using TM-T88VII Utility for Windows or EpsonNet Config, SimpleAP is disabled.
To activate SimpleAP again, start it by selecting the SimpleAP menu that is available after printing a status sheet,
or reset the network settings.
"Setting up from a Windows Computer using SimpleAP" on page 36
"Resetting the Interface Settings" on page 83
to the printer.
at the same time.
started, the wireless LAN connection is temporarily disconnected.
may also occur with a device running other OS. If that happens, delete the printer's SimpleAP SSID
profile in the Wi-Fi settings of the Windows, iOS, or Android device, and then connect to the printer
again.
SimpleAP Start
SSID : DIRECT-TM-T88VII- XXXXXXXXXX
Chapter 1 Product Overview
Serial number of the printer
26