Environmental Conditions - Epson TM-T88VII Technical Reference Manual

Environmental Conditions

Temperature/ Operating
Humidity
Storage
(Factory packing)
Vibration When packed
resistance
Shock resistance When packed
When unpacked
Acoustic noise (operating)
Dust and drip proofness function
Altitude
∗ The value measurements are equivalent to JISC0920 (IEC60529:2001) standard. Therefore, safety standard
application, and failure and breakage of the printer are not guaranteed.
5 to 45°C {41 to 113°F}, 10 to 90% RH (See the operating temperature and
humidity range below.)
-10 to 50°C {14 to 122°F}, 10 to 90% RH (except for paper)
[%RH]
90
65
Operating environment
range
10
5
Frequency: 5 to 55 Hz
Acceleration: Approximately 19.6 m/s
Sweep: 10 minutes (half cycle)
Time: 1 hour
Orientation: x, y, and z
There is no external or internal visible damage and the unit operates
normally after being subjected to vibration.
Packing: Epson standard package specifications
Height: 60 cm {23.62"}
Orientation: 1 corner, 3 edges, and 6 surfaces
There is no external or internal visible damage and the unit operates
normally after being dropped.
Height: 5 cm {1.97"}
Orientation: Lift one edge and release it (for all 4 edges)
There is no external or internal visible damage and the unit operates
normally after being dropped while not operating.
Approximately 52 dB (bystander position)
Note: The values above are measured in the Epson evaluation condition.
Acoustic noise differs depending on the paper used, printing
contents, and the setting values, such as print speed or print
density.
*
IPX2 equivalent
Note: Roll paper side is excluded.
When the rubber feet sections are installed horizontally.
Up to 3,000 m
34°C, 90%
31°C, 90%
34°C, 75%
40°C, 65%
45°C, 50%
45°C, 43%
34 40 45 [°C]
Ambient temperature
2
{2G}
Appendix
Specified original paper other
than below
Specified original paper:
P5047(46)
115