Advertisement
__ 2. Remove the processor card assembly A by doing the following:
__ 3. Before you remove the blank filler cards and install the memory into the
22
30xx Memory Card Installation V5R2
video.
__ a. Unlatch the two latches until the card assembly slightly "pops" out.
__ b. Pull on both latches at the same time to remove the card assembly
from the system unit.
__ c. Place the card assembly on a static protective bag.
Note: If A is full, remove processor card assembly B . If B is
full, remove processor card assembly C .
card assembly, read the following:
v Figure 19 on page 23 shows memory card locations on the main storage
card assembly.
v Fill positions C and D before installing memory cards in positions E, F,
G, and H.
v Install memory in sets of four. For example, you cannot fill only
positions E and G and later fill positions F and H. You must install all
four memory cards at one time.
v Pairs of memory cards must be either 256 MB, 512 MB, 1 GB or 2 GB.
Pairs installed in E and G must match pairs installed in F and H.
v Go to step 4 on page 23.
View
Advertisement
