Advertisement
Figure 6. Location of card assemblies in 820 system unit
__ 19. Figure 6 shows the location of the 2884 card assemblies B , C and the
__ 20. Remove the empty card assembly C by doing the following:
__ 21. Locate the new 2884 card assembly.
__ 22. Before you remove the blank filler cards and install the memory into the
8
30xx Memory Card Installation V5R2
__
Yes: Continue with the next step.
__
No: Go to step 31 on page 10.
processor card assembly A in a model 820.
__ a. Unlatch the two latches on the 2884 until the card assembly slightly
"pops" out.
__ b. Pull on both latches at the same time to remove the card assembly
from the system unit.
card assembly, read the following:
v Figure 7 on page 9 shows memory card locations on the main storage
card assembly.
v Fill positions C and D before installing memory cards in positions E, F,
G, and H.
v Install memory in sets of four. For example, you cannot fill only
positions E and G and later fill positions F and H. You must install all
four memory cards at one time.
v Pairs of memory cards must be either 128 MB, 256 MB, 512 MB, or 1 GB.
Pairs installed in E and G must match pairs installed in F and H.
Advertisement
