Table of Contents
Advertisement
Adva nc e d Sug g e stio ns
• Try to access the NBG7815 using another service, such as Telnet. If you can access the NBG7815,
check the remote management settings and firewall rules to find out why the NBG7815 does not
respond to HTTP.
• If your computer is connected to the
connected to a
I can see the
L o g in
• This can happen when you fail to log out properly from your last session. Try logging in again after 5
minutes.
• Disconnect and re-connect the power adaptor or cord to the NBG7815.
• If this does not work, you have to reset the device to its factory defaults. See
147.
14.4 Inte rne t Ac c e ss
I cannot access the Internet.
• Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide.
• Go to
Expe rt
If the NBG7815 is in
or router with Internet access. Your computer and the NBG7815 should be in the same subnet.
If the NBG7815 is in
router with Internet access and your computer is set to obtain an dynamic IP address.
• If the NBG7815 is in
the wizard or the WAN screen. These fields are case-sensitive, so make sure [Caps Lock] is not on.
• If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless client
are the same as the settings in the AP.
• Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.
• If the problem continues, contact your ISP.
I cannot access the Internet anymore. I had access to the Internet (with the NBG7815), but my
Internet connection is not available anymore.
• Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide and
• Reboot the NBG7815.
Chapter 14 Troubleshooting
/
port.
L AN
ET HERNET
screen, but I cannot log in to the NBG7815.
>
Ma inte na nc e > O pe ra tio n Mo de
, make sure the WAN port is connected to a broadband modem
Sta nda rd Mo de
, make sure the WAN port is connected to a broadband modem or
Bridg e Mo de
, make sure you entered your ISP account information correctly in
Sta nda rd Mo de
Section 1.7 on page
NBG7815 User's Guide
port or is connected wirelessly, use a computer that is
WAN
. Check your System Operation Mode setting.
14.
146
Section 14.5 on page
Advertisement
Table of Contents
