Table of Contents
Advertisement
The following table describes the labels in this screen.
Table 44 Settings > Firewall > IPv6 Firewall
L ABEL
Configuration
Simple Security
Rule Status
Action
Firewall Rule
No.
Service Name
MAC Address
Dest IP Address
Source IP Address
Dest Port Range
Source Port Range
Protocol
Actions
Apply
Cancel
12.3.1 IPv6 Fire wa ll- Add Rule Sc re e n
Use this screen to configure IPv4 firewall rule. Click
the following screen.
Chapter 12 Security
DESC RIPT IO N
Select
to enabled simple security on your NBG7815.
Ena b le
Select
to enabled rule status on your NBG7815.
Ena b le
Select
to silently discard the packets which meet the firewall rules. The others are
DRO P
accepted.
Select
to allow the passage of the packets which meet the firewall rules. The others
AC C EPT
are blocked.
This is your firewall rule number. The ordering of your rules is important as rules are applied in
turn.
This is a name that identifies or describes the firewall rule.
This is the MAC address of the computer for which the firewall rule applies.
This is the IP address of the computer to which traffic for the application or service is
entering.
This is the IP address of the computer to which traffic for the application or service is
initialized.
This is the port number/range of the destination that defines the traffic type, for example
TCP port 80 defines web traffic.
This is the port number/range of the source that defines the traffic type, for example TCP
port 80 defines web traffic.
This is the protocol (
,
T C P
UDP
apply the firewall rule.
Click
to remove the firewall rule.
Click
to edit the firewall rule.
Click
to save the settings.
Apply
Click
to restore your previously saved settings.
C a nc e l
NBG7815 User's Guide
131
or
) used to transport the packets for which you want to
IC MPv6
>
>
Se tting s
Fire wa ll
IPv6 Fire wa ll
>
to open
Add Rule
Advertisement
Table of Contents
