Table of Contents
Advertisement
The table below describes the labels in the screen.
Table 40 Settings > LAN > LAN IP
L ABEL
IP Address setting
Obtain an IP Address
Automatically (DHCP)
Static IP Address
IP Address
Subnet Mask
Gateway
DNS Server
First DNS Server
Second DNS Server
Third DNS Server
Apply
Cancel
11.5 IPv6 L AN Sc re e n
Use this screen to configure the IP address for your NBG7815 on the LAN. Click
to show the following screen.
Note: This is not available if you are using bridge mode.
Chapter 11 LAN
DESC RIPT IO N
When you enable this, the NBG7815 gets its IP address from the network's DHCP server
(for example, your ISP). Users connected to the NBG7815 can now access the network
(i.e., the Internet if the IP address is given by the ISP).
The Web Configurator may no longer be accessible unless you know the IP address
assigned by the DHCP server to the NBG7815. You need to reset the NBG7815 to be
able to access the Web Configurator again (see
on how to reset the NBG7815).
Also when you select this, you cannot enter an IP address for your NBG7815 in the field
below.
Click this if you want to specify the IP address of your NBG7815. Or if your ISP or network
administrator gave you a static IP address to access the network or the Internet.
Type the IP address in dotted decimal notation. The default setting is 192.168.123.2. If
you change the IP address you will have to log in again with the new IP address.
The subnet mask specifies the network number portion of an IP address. Your NBG7815
will automatically calculate the subnet mask based on the IP address that you assign.
Unless you are implementing subnetting, use the subnet mask computed by the
NBG7815.
Enter a gateway IP address (if your ISP or network administrator gave you one) in this
field.
Select
if your ISP dynamically assigns DNS server information (and
O b ta ine d Fro m ISP
the NBG7815's WAN IP address). The field to the right displays the (read-only) DNS server
IP address that the ISP assigns.
Select
if you have the IP address of a DNS server. Enter the DNS server's IP
Use r- De fine d
address in the field to the right. If you chose
to 0.0.0.0,
changes to
Use r- De fine d
choice to
, and enter the same IP address, the second
Use r- De fine d
changes to
after you click
No ne
Select
if you do not want to configure DNS servers. If you do not configure a DNS
No ne
server, you must know the IP address of a computer in order to access it.
Click
to save your changes to the NBG7815.
Apply
Click
to reload the previous configuration for this screen.
C a nc e l
NBG7815 User's Guide
123
Section 13.6 on page 139
, but leave the IP address set
Use r- De fine d
after you click
No ne
Apply
.
Apply
Se tting s
for details
. If you set a second
Use r- De fine d
>
>
L AN
IPv6 L AN
Advertisement
Table of Contents
