Setting Dfs And Regulatory Parameters; Figure 29: Region/Country Code On Ap "Configuration => General" Page, System Release 11.2; Figure 30: Region/Country Code On Ap "Configuration => General" Page, System Release 12.1 - Cambium Networks PMP 400 Series Configuration And User's Manual

PMP 400/430 and PTP 200/230 Series Configuration and User Guide

Setting DFS and Regulatory Parameters

Setting the Region/Country Code
All System Release 11.2 modules display Region Code settings on the Configuration => General page as
shown in Figure 29 on page
All System Release 12.1 modules display Region Code and Country Code settings on the Configuration =>
General page as shown in
On new modules from the factory, or after resetting to factory defaults, the operator should set this Region
Code/Country Code consistent with their country or region. For countries or regions not listed in the Region
Code/Country Code drop-down, set the Region Code consistent with your country's regulatory requirements.
For example, several countries in South America follow the same DFS regulations as Brazil, so in those
countries the Region Code should be set to "Brazil".
IMPORTANT!
Operators under regulatory requirements for DFS must ensure that
Canopy parameters Region Code/Country Code are set correctly. This
applies to initial configuration, after a module is reset to factory defaults,
or after a module is upgraded.
An AP or BHM will not transmit if the Region Code/Country Code are configured to "None".
IMPORTANT!
On APs or BHMs received from the factory, with Region Code/Country
Code set to "None", the operator must set the Region Code before the
module will transmit. The same is true of APs and BHMs which have
been reset to factory defaults.
Figure 29: Region/Country Code on AP "Configuration => General" page, System
Release 11.2
Figure 30: Region/Country Code on AP "Configuration => General" page, System
Release 12.1
pmp-0042 (March 2014)
60.
Figure 30 on page 60.
Page 60 of 98