Wiring Diagram - Napoleon Knightsbridge GDS60-1N Installation And Operation Manual

fi nishing

7.0 wiring diagram

EN
WARNING
!
• Do not wire 110 volts to the valve or wall switch.
TRANSFORMER
BATTERY
HOUSING
DC SUPPLY
WHERE APPLICABLE, APPLIANCES WITH "B" VENT ADAPTORS MUST HAVE THE SPILL SWITCH WIRED IN
SERIES WITH EITHER THE EXISTING SWITCH OR OPTIONAL WALL SWITCH, THERMOSTAT OR REMOTE.
note:
This appliance comes equipped with a battery back-up. If this backup is used, install 4 'AA' batteries (not sup-
plied) into the holder and connect to the wire harness. Connect the battery holder to the wire harness before
using the appliance. Place near the IPI board. If the backup is used, it must be connect to this 6 volt battery
pack (supplied).
42
W415-1328 / C / 12.06.18
ACS/IPI
SWITCH
(OPTIONAL)
ON / OFF
SWITCH
ON / OFF
DISCONNECT THESE
CONNECTIONS TO THE
ON/OFF SWITCH. CONNECT
AN OPTIONAL THERMOSTAT
OR REMOTE CONTROL AND
(IF ALLOWED WITH THIS
APPLIANCE) A "B" VENT
ADAPTOR.
DFC Digital Fireplace Control
DC Direct Current
IPI Intermittent Pilot Ignition
Continuous Pilot Ignition
CPI
ACS Anti-Condensation Switch
IPI / CPI
GROUND
EYELET
GROUND
Legend
GREEN
ORANGE
ELECTRONIC
VALVE
VALVE
IPI BOARD
DFC
-