Preparation And Use - Clarke DWS225LR Operation & Maintenance Instructions Manual

PREPARATION AND USE

FITTING A SANDING PAD
1. Ensure the sander is switched off
and the plug is removed from the
socket.
2. Remove the sanding disc.
3. Place the allen key in the
hexagon hole in the centre of the
sanding pad and rotate
clockwise to remove pad
4. Place replacement sanding pad and tighten allen key anticlockwise.
FITTING SANDING DISC
1. Ensure the sander is switched off
and the plug is removed from the
socket.
2. Select the sanding disc to be
used.
• This MUST be the correct 10
hole 225mm diameter disc with
hook and loop backing.
3. Line up the holes in the disc with those on the sanding pad.
• This is necessary for dust extraction purposes.
4. Press the disc firmly onto the pad to secure it using the hook & loop
backing.
FITTING THE EXTENSION HANDLE & DUST BAG
1. Unfold handle and lock in place
with locking wheel (P10).
2. Loosen the locking wheel on the
underside of the handle.
3. Insert extension handle to
required length and tighten
locking wheel
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9