Optional Installation; Blower Kit Installation - Napoleon S25 Installation And Operation Manual

5.1

blower kit installation

WARNING
!
• Risk of fire and electrical shock!
• Turn off the gas and electrical power before servicing this appliance.
• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using
non-listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could
result in a safety hazard and will void the warranty and certification.
• Ensure that the fan's power cord is not in contact with any surface of the appliance to prevent electrical
shock or fire damage. Do not run the power cord beneath the appliance.
• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excess
wire is contained, prevent it from making contact with moving or hot objects.
Drywall dust will penetrate into the blower bearings, causing irreparable damage. Care must be taken to prevent
drywall dust from coming into contact with the blower or its compartment. Any damage resulting from this
condition is not covered by the warranty policy. Use of the blower increases the output of heat.
Provisions have been made on this appliance to install an optional blower kit (NEP70) that comes complete with a
variable speed switch to turn the blower ON/OFF, as well as to adjust the blower speed.
Adjustment Screws
AN OPTION OR COMES STANDARD WITH THE
1. Ensure the thermal disc
bracket is in the correct
position (Fig. 5-1).
2. Remove the two knockouts
from the back of the
appliance.
3. Install the blower and
housing as shown (Fig. 5-2)
using 4 screws (supplied).
4. Loosen the adjustment
screws.
5. Reach between the outer panel and the firebox, then slide the thermal disc bracket until the thermal disc is
touching the rear of the firebox (Fig. 5-1).
note:
For optimal performance, the thermal disc MUST make contact with the firebox.
6. Re-secure the adjustment screws to hold the thermal disc bracket in place.
SPECIFIC BLOWER INSTALLATION
INSTRUCTIONS MUST BE ADDED HERE.
Illustration shows
THIS TEMPLATE MUST BE USED WITH ANY
appliance with
Middle
knockouts removed.
APPLIANCE THAT OFFERS THE BLOWER AS
Heat
Outer
Shield
Panel
Firebox
APPLIANCE... AS PER THE STANDARD.
Thermal
Disc
Thermal Disc
Bracket
Fig. 5-1

5.0 optional installation

ADJUSTMENT
SCREWS
THERMAL DISC
BRACKET
35.1
Fig. 5-2
W415-2837 / 08.11.20
EN
25