Bath Operation - Kohler K-98155X Installation And Care Manual

Installation (Cont.)
Slide the sliding slip to unlock the panel. Touch the electronic drain on/off button "
¨
The pink light flashes. Fill the bath to a level at least 10 cm above the top of the highest airjet.
Refer to "Bath Operation" to make sure that every function works well.
¨
Check the drain piping for leaks. Repair any leaks.
¨
Operate the bath and check for air flow through the airjets. Check the air piping for air leaks.
¨
Stop the bubble massage and drain the water.
¨
Return the plastic drop cloth or other protective sheeting to the bath. Check the drain connections for leakage.
¨
+
c
o
38
-
Water Temperature
I. Drilling And Cutting Acrylic
DRILLING: Small holes can be drilled with a twist drill, but the cutting edge MUST be backed off with an oil
stone (the sharp edge dulled). Large holes must be drilled with a hole saw. Maximum drill size-12mm. Drill
speeds-6mm x 1800 RPM-12 mm x 900 RPM.
NOTE: Always drill from acrylic surface.
CUTTING: If for any reason the acrylic requires cutting, use a fine tooth hacksaw and proceed with caution.
Edges can be smoothed with a second-cut file and medium-fine sandpaper. If the surface of the acrylic should
happen to be damaged, it can be restored by polishing with an abrasive cleaner. Deep scratches can be removed
by rubbing with 600 grade wet & dry sandpaper then polishing.
J. Clean-Up After Installation
Clean the area around the blower motor of all dust and debris.
¨
Use warm water and a liquid detergent to clean the surface of the bath with airjets. Do not use abrasive
¨
cleansers, as they may scratch and dull the surface. Do not use powdered cleaners unless the cleaner is fully
dissolved in water. Solid substances could block the airjets. Do not use bleach or ammonia cleaning solutions.
Chemically active cleaning solutions can damage the bath surface. Refer to the homeowners guide for normal
cleaning recommendations.

Bath Operation

A. Fill the Bath
CAUTION: Risk of product damage. Ensure that the area around the blower motor is free of sawdust,
insulation, dirt, or other small loose debris. Such material could clog the blower motor air ducts and
reduce the air flow through the blower motor.
NOTE: Please read these steps carefully before you operate your bath with airjets. Troubleshoot any problems
using the "Troubleshooting" section.
NOTE: Please do not use the bath in case of outage. In this case, the electronic drain automatically opens and the
bath can not be filled with water.
1204153-X2-A
Manual Purge
Electronic Drain On/Off
Pump On/Off
8
" to close the drain.
Decreases/Increases Flow
Kohler Co.