Keypad Operation; Function Operation - Kohler K-98155X Installation And Care Manual

Freestanding bubblemassage bath
Table of Contents

Advertisement

Available languages

Available languages

Bath Operation (Cont.)
B. Keypad Operation
When the finger is within 1-3 cm to the panel, lights on the sliding slip will flash one by one along "
¨
direction. Slide along "
If the panel is not operated within 30 seconds (no drops of water splash into the sensing range of the panel),
¨
it will be automatically locked and enter energy-saving mode with no light display.
Function Operation
NOTE: Before operating the panel, please confirm that there is no obvious water stains on the panel. If there is
any, please first wipe it clean.
Electronic Drain
Slide the sliding slip to unlock the panel. Start the drain by touching the button "
flashes. Touch again to stop it ,the pink light flashes. When touching this button, a slight sound can be heard from
the drain at the bottom of the bath.
Bubble Massage
Slide the sliding slip to unlock the panel. Touch the button "
Touch again to stop it, blue light half flashes.
Touch the button "
Bubble Adjustment
Slide the sliding slip to unlock the panel. When the blower motor is running, slide in "
the air flow and the light gradually flashes from white to blue as the finger moves along "
Slide in "
" direction to decrease the air flow, the light gradually dies out from blue to white as the finger
moves along "
reaches its minimum, only the white light will flash.
Manual Cleaning
Slide the sliding slip to unlock the panel. Start the blower motor by touching the button "
flashes. It will automatically stop after running for about 2 minutes.
Automatic Cleaning
After running for 20 minutes, BubbleMassage will automatically turn off. Press electronic drain on/off button to
open the drain. When water level drops below airjet holes, auto cleaning will activate for 2 minutes.
+
c
o
38
-
Water Temperature
Kohler Co.
" direction, the panel will be unlocked and activated.
" The blower motor will automatically stop after running for about 20 minutes.
" direction. When air flow reaches its maximum, all the blue light will flash. When air flow
Manual Purge
Electronic Drain On/Off
" to start the blower motor, blue light flashes.
Pump On/Off
9
" once, the green light
" direction to increase
" direction.
" the orange light
Decreases/Increases Flow
1204153-X2-A
"

Advertisement

Table of Contents
loading

Table of Contents