Table of Contents
Advertisement
Available languages
Available languages
Bath Operation
A. Fill the Bath
CAUTION : Risk of product damage.
insulation, dirt, or other small loose debris. Such material could clog the pump motor ducts and reduce the
air flow through the pump motor.
NOTE: Please read these steps carefully before you operate your bath. Troubleshoot any problems using the
"Troubleshooting" section.
Turn the drain controller counterclockwise to close the drain.
Fill the bath to a level above the top of the higher jet around 50 mm.
NOTE: Massage function may fail to start if water level is too low.
B. Keypad and Operation
Blower Pump On/Off
NOTE: When any function button works, there is a "beep" indication sound.
Power On/Off
Press the button "
Press the button "
LED On/Off
Press the button "
Press the button "
Whirlpool Pump On/Off
Press the button "
are activated.
Press the button "
When the water level lowers than the setting value, the whirlpool pump automatic stops working, at the same
time
the red light of
is on again and the pump start to work.
Blower Pump On/Off
Press the button "
are activated.
Press the button "
1334405-EM2-A
Whirlpool Pump On/Off
"
on the user keypad to start the system and enter to standby mode. The red light is on.
"
again to stop the system.
"
on the user keypad to turn on the LED light.
"
again to turn off the LED light.
"
on the user keypad to start the whirlpool pump. The red light is on, the back jets
"
again to stop the whirlpool pump. The back jets are deactivated.
the button "
"
is
off. When anytime the water level achieve the setting value, the red light
"
on the user keypad to start the blower pump. The red light is on, the bottom jets
"
again to stop the blower pump. The bottom jets are deactivated.
Ensure that the area around the blower motor is free of sawdust,
LED On/Off
8
Power On/Off Switch
Kohler Co.
Advertisement
Table of Contents
