Table of Contents
Advertisement
5.1.30 Set relative horizontal printing position ESC \ nL nH
ESC \ nL nH
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Set relative horizontal printing position
1BH, 5CH, nL, nH
(nL + 256 x nH) x (relative horizontal position setting value) * 25.4mm
1) If bit 6 of nH is 1, then nH will be negative, and the Most Significant Bit (bit 7) is
presumed to be 1. Negative values are expressed in two's complement.
2) The printing position in the X direction is incremented from the current X position by the
following amount
(256 x nH + nL) x (relative horizontal position setting value).
The relative horizontal position setting value is set with the ESC (U command.
The defined default relative horizontal position setting value is 0.141mm(1/180inch).
3) If the position set by this command is within the non-printable area, it is ignored.
However, it is possible to shift to a position in the right margin area.
-
[Setting] Commands whose settings are affected by this command.
None
[Setting] Commands that change the effects of this command.
None
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
The relative horizontal position setting value is set by the ESC (U command.
The relative horizontal position setting value is reset to its initial state by the ESC @ or the
ESC (G commands.
Ver 1.00
[Operation]
2013/12/18
Page: 57
Advertisement
Table of Contents
