Table of Contents
Advertisement
5.1.18 Monochrome Mode / Color Mode Selection ESC ( K nL nH m n
ESC ( K nL nH m n
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Supplementary Note]
[Related Commands]
Revision: 1
Monochrome Mode / Color Mode Selection
1BH, 28H, 4BH, nL, nH, m, n
nL=01H, nH=00H
m=00H
n=00H, 01H, 02H
1) Monochrome mode or color mode is selected.
n=00H: Default mode (color mode)
n=01H: Monochrome mode
n=02H: Color mode
2) When monochrome mode is selected, the color selection commands ESC r and ESC (r are
ignored. Furthermore, the results of color raster commands which have been dispatched
in monochrome mode are unpredictable.
3) If n has any value other than the above, this command is ignored.
Default mode.
Higher throughput speeds may be obtained for printing monochrome data when monochrome
mode is selected rather than color mode. For printing in color, the color mode must be
selected.
[Setting] Commands whose settings are affected by this command.
When monochrome mode is selected, color setting modes using the ESC r and ESC (r
commands are ignored.
[Setting] Commands that change the effects of this command.
The default mode is selected by the ESC @ command.
[Operation] Commands whose functionality is affected by this command.
None.
[Operation] Commands that change the effects of this command.
None.
Ver 1.00
[setting]
2013/12/18
Page: 43
Advertisement
Table of Contents
