Select Graphics Mode Esc - Epson XP-410 Programming Manual

5.1.11 Select graphics mode ESC (G nL nH m
ESC (G nL nH m
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Select graphics mode
1BH, 28H, 47H, nL, nH, m
nL=01H, nH=00H
m=01H or 31H
1) Shifts to graphics mode.
2) If m has any value other than the above, this command is ignored.
3) Printing of lines up to the present line is started, and the printer waits until the printing is
completed.
4) The various settings are the same as when the power is turned on.
5) The page management coordinate system and the position management coordinate system
are set by taking the printing position in the Y direction at the time of setting as the origin
on the Y axis.
6) The printing position in the X direction is set to the origin upon the X axis.
7) The microweave printing mode selection command becomes effective.
Character mode.
[Setting] Commands whose settings are affected by this command.
Default character mode selection made by the ESC @ command is changed.
[Setting] Commands that change the effects of this command.
The graphics mode is cancelled by the ESC @ command.
[Operation] Commands whose functionality is affected by this command.
In graphics mode, only the following commands are valid:
LF ESC (C
FF ESC ( \
CR ESC (U
ESC EM ESC (V
ESC. ESC (r
ESC + ESC (v
ESC @ ESC \
ESC (c ESC $
ESC (i ESC r
ESC (K ESC U
ESC ( e
[Operation] Commands that change the effects of this command.
None
Ver 1.00
[Operation]
2013/12/18
Page: 36