Table of Contents
Advertisement
5.1.6 Control paper loading/ejecting ESC EM n
ESC EM n
[Name]
[Format]
[Range of Definition]
[Function]
[Initial State]
[Related Commands]
Revision: 1
Control paper loading/ejecting
1BH, 19H, n
n=31H, 52H
(="1", "R")
1) The CSF (cut sheet feeder) receives the following commands, according to the value of n:
n=31H select bin 1for the next paper feeding, and for every paper fed thereafter
n=52H eject paper
2) If n has any value other than the above, this command is ignored.
3) The ESC EM "R" will only eject paper fed from the CSF. If the paper being fed was not
fed by the CSF, this command is ignored.
4) Bin selection settings apply to the next and subsequent paper feedings.
5) After the ESC EM "R" command ejects the paper, the printing position in the X direction is
set to the origin on the X axis.
-
[Setting] Commands whose settings are affected by this command.
None
[Setting] Commands that change the effects of this command.
Bin selection is reset to its initial state by the ESC @ command.
[Operation] Commands whose functionality is affected by this command.
None
[Operation] Commands that change the effects of this command.
None
Ver 1.00
[Setting]
2013/12/18
Page: 31
Advertisement
Table of Contents
