Modify Banner And Prompt Commands - D-Link xStack DES-3800 Series Cli Manual

xStack DES-3800 Series Layer 3 Stackable Fast Ethernet Managed Switch CLI Manual

Modify Banner and Prompt Commands

Administrator level users can modify the login banner (greeting message) and command prompt by using
the commands described below.
Command
config
greeting_message
config command_
prompt
The Modify Banner and Prompt commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
config greeting _message
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To modify the banner to read "this is the best switch ever":
DES-3800:4#config greeting_message
Parameters
{default}
[<string 16> | username | default]
Used to configure the login banner (greeting message).
config greeting _message {default}
Users can use this command to modify the login banner (greeting
message).
default – If the user enters default to the modify banner command,
then the banner will be reset to the original factory banner.
To open the Banner Editor, click enter after typing the config
greeting_message command. Type the information to be displayed
on the banner by using the commands described on the Banner
Editor:
Quit without save:
Save and quit:
Move cursor:
Delete line:
Erase all setting:
Reload original setting:
Only administrator-level users can issue this command. Other
restrictions include:
•
If the "reset" command is executed, the modified banner
will remain modified. However, the "reset system"
command will reset the modified banner to the original
factory banner.
•
The capacity of the banner is 6*80. 6 Lines and 80
characters per line.
•
Ctrl+W will only save the modified banner in the DRAM.
You need to type "save" command to save it into FLASH.
•
Only valid in threshold level.
317
Ctrl+C
Ctrl+W
Left/Right/Up/Down
Ctrl+D
Ctrl+X
Ctrl+L
46